1
?/DIV>
Dual Slot PCI-E Hot Plug Controllers
The ISL6113, ISL6114 both target the PCI-Express Add-in card
hot swap application. Together with a pair of N-Channel and
P-Channel MOSFETs, and two sense resistors per slot, either
provides compliant hot plug power control to any combination
of two PCI-Express X1, X4, X8 or X16 slots.
The ISL6113, ISL6114 feature a programmable current
regulated (CR) maximum level for a programmable period to
each voltage load so that both fault isolation protection and
imperviousness to electrical transients are provided.
For each +12V supply, the CR level is set by a resistor value
depending on the needs of the PCI-Express connector (X1, X4,
X8 or X16) to be powered. This resistor is a sub-ohm standard
value current sense resistor one for each slot and the voltage
across this resistor is compared to a 50mV reference providing
a nominal CR protection level adequately above the specific
slot maximum limits. The 3.3V supply uses a 15m?sense
resistor compared to a 50mV reference to provide 3.3A of
maximum regulated current to all connector sizes. The
3.3VAUX is internally monitored and controlled to provide a
nominal maximum of 1A of AUX output current.
The CR period for each slot is set by a separate external
capacitor on the associated CFILTER pin. Once the CR period
has expired, the IC then quickly turns off its associated FETs
thus unloading the faulted card from the supply voltage rails. A
nominal 3.3V must always be present on the AUXI pin for
proper IC bias; this should be the 3.3VAUX supply if used, if not
the AUXI pin is tied directly to the 3VMAIN supply. Both ICs
employ a card presence detection input that disables the MAIN
and AUX enabling inputs if it is not pulled low. Output voltage
monitoring with both PCI-E Reset Not and Power Good Not
reporting along with OC Fault reporting are provided. Whereas
the ISL6113 has the same GATE drive and response
characteristics as the ISL6112, the ISL6114 has a lower turn-on
GATE drive current allowing for the use of smaller
compensation capacitors and thus much faster response to
Way Overcurrent (WOC) conditions. Additionally, the ISL6114
does not turn-on with the CR feature invoked as do the
ISL6112, ISL6113 allowing for shorter CR programmed
periods.The ISL6113, ISL6114 are footprint compatible for all
common pins, but not entirely function compatible with the
ISL6112s QFN package as there are I/O differences.
Features
" Dual PCI-E Slot Hot Swap Power Control and Distribution
" Highest Accuracy External R
SENSE
Current Monitoring
On Main Supplies
" Programmable Current Regulation Protection Function for
X1, X4, X8, X16 Connectors
" Programmable Current Regulation Duration
" Programmable In-rush Protection During Turn-On
" Latch-off or Retry Modes After Failure
" Pb-free (RoHS Compliant)
Applications
" PCI-Express Servers
" Power Supply Distribution and Control
" Hot Swap/Electronic Breaker Circuits
" Network Hubs, Routers, Switches
" Hot Swap Bays, Cards and Modules
FIGURE 1. TYPICAL ISL6113, ISL6114 BLOCK DIAGRAM
APPLICATION IMPLEMENTATION
3VGATEA
3VINA
12VGATEA
12VINA
ISL6113, ISL6114
3VSENSEA
VSTBYB
VAUXA
12VSENSEA
3VGATEB
3VINB
12VGATEB
12VINB
3SENSEB
VAUXB
12VSENSEB
PRSNTA
PRSNTB
FORONA
FORONB
AUXENB
ONB
ONA
GPI_A0
GPI_BO
GPO_A0
GPO_B0
FAULTA
FAULTB
PWRGDA
PWRGDB
CFILTERA
PERSTB
PERSTA
GND
12VOUTA
3VOUTA
3VOUTB
12VOUTB
CFILTERB
VSTBYA
IF 3.3VAUX NOT
IMPLEMENTED
AUXENA
IF 3.3VAUX NOT
IMPLEMENTED
FN6457.0
ISL6113, ISL6114
Data Sheet
September 25, 2007
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2007. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
FN6457.0
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
4006-020
LED CONST CURRENT RESISTOR 20MA
A8450KLBTR-T
IC REG QD BUCK/LINEAR 24-SOIC
AD595CD
IC THERMOCOUPLE INSTR AMP 14CDIP
AD597AHZ
IC THERMOCOUPLE COND TO-100-10
AD7314ARMZ-REEL7
IC SENSOR TEMP 10BIT DGTL 8-MSOP
AD7814ARTZ-REEL
IC TEMP SNSR 10BIT DGTL SOT23-6
AD7818ARZ
IC ADC 10BIT W/TEMP SENSOR 8SOIC
AD8210WYRZ-R7
IC CURRENT MONITOR 0.5% 8SOIC
相关代理商/技术参数
ISL6114IRZA-T
功能描述:热插拔功率分布 4 8LD 7X7 DL SLOT PCI-E HOT PLUG CNTRL RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
ISL6115
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Power Distribution Controllers
ISL6115 WAF
制造商:Intersil Corporation 功能描述:
ISL6115_07
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Power Distribution Controllers
ISL6115A
制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:12V Power Distribution Controllers
ISL6115ACBZ
功能描述:热插拔功率分布 W/ANNEAL 8LD +12V HOT PLUG CNTRLR RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
ISL6115ACBZ-T
功能描述:热插拔功率分布 W/ANNEAL 8LD +12V HOT PLUG CNTRLR RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube
ISL6115AEVAL1Z
功能描述:EVAL BOARD 1 FOR ISL6115A RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:* 标准包装:1 系列:PCI Express® (PCIe) 主要目的:接口，收发器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要属性:- 次要属性:- 已供物品:板